Kel-Tec Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
I went to hardware store bought shrink tubing for 1/2 wiring,cut to fit over the charging handle shrank it with a hair dryer,cushioned it for $1.54 untill gunnut gets to making his folding charger.
 

·
Registered
Joined
·
17 Posts
I bought a black rubber stopper at lowes for 83 cents and used apiece of brass1/4 inch tubing to hollow out the center . Im thinking a person could use an expended 223 brass to do the same. The stoppers are tapered so I put the larger end at the bottom I also used a slightly larger piece of tubing (once again I think a peice of 7.62 brass would work) to cut a recess at the bottom, to seat around the existing bottom lug of the handle. Put on a drop of soap and muscled it on, makes for a real positive pull but still easy on the hand.
 
1 - 2 of 2 Posts
Top