Kel-Tec Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
My new P3AT also had the sagging clip problem that many have discussed here. The end of the clip was almost in the trigger area. I called Kel-Tec and they sent me a new clip after confirming I had the right part number clip now.

The new one was no better. A little closer examination revealed a bit too much metal in one of the bends so out came the grinder.

If you're interested in the fix I posted some pictures here.

www.mcconnellsweb.com/p3at_clip/clip_fix.htm

I'm happily clipped now!


Bob
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top