Kel-Tec Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I have heard of the "White" eraser method to add to the Kel Tec's P-11, 9mm.

Can this same method be applied to the P-32? Have any of you done this and if so did it help in regard to the lengthy trigger pull?

I noticed Harlequin in one of his reponses referred to this.
 

·
Banned
Joined
·
5,800 Posts
Yep, it can be done with the P-32 and P-3AT...
However, there's so little overtravel on the trigger of these pistols I haven't bothered with them.
Then again, your pistol may vary... so have at it!
Flyer
 

·
Registered
Joined
·
36 Posts
I'm hardly an expert. But I have done it with my P32 using a black eraser and it works. If it's more than an eighth of an inch I'd be surprised.
 
1 - 4 of 4 Posts
Top