Kel-Tec Forum banner
1 - 4 of 4 Posts

·
Banned
Joined
·
5,800 Posts
Yep!
Turn it upside down and locate the little hole with a button in the bottom of the baseplate. With a pen or pencil point, push in on the button until with thumb pressure you can slide the bottom off towards the front. Careful here; the mag spring and spring plate are gonna want to fly.
Remember which way the mag spring comes out, and reassemble the same way... compress the mag spring onto the follower, push into the mag, then put the mag plate on top of the spring, placing the two little raised tabs inside the loops of the spring. Then, slide the base back on from the front, until it clicks into place.
Hope this helps!
Flyer
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Re:

Flyer said:
Yep!
Turn it upside down and locate the little hole with a button in the bottom of the baseplate. With a pen or pencil point, push in on the button until with thumb pressure you can slide the bottom off towards the front. Careful here; the mag spring and spring plate are gonna want to fly.
Remember which way the mag spring comes out, and reassemble the same way... compress the mag spring onto the follower, push into the mag, then put the mag plate on top of the spring, placing the two little raised tabs inside the loops of the spring. Then, slide the base back on from the front, until it clicks into place.
Hope this helps!
Flyer
Thanks Flyer.I'll do that.Pistol
 

·
Registered
Joined
·
205 Posts
push the button and slide off the plate:


(Warning: spring under pressure)
 
1 - 4 of 4 Posts
Top