Kel-Tec Forum banner
1 - 3 of 3 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
I recently saw a website that shows using JB Weld epoxy to make an overtravel stop by filling part of the cavity where the trigger axis arm moves.

Has anyone done this or a similar mod?

I was also wondering if it would be possible to drill a hole in the right place behind the trigger axis arm and insert a small music spring wire pin to perform the same function.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.