Kel-Tec Forum banner
1 - 2 of 2 Posts

· Premium Member
Joined
·
5,516 Posts
Todd_In_Texas,

1) 600 grit sandpaper on feed ramp. Lightly sand until you get a mirror shine. (washboard effect from rough machining on feed ramp) Don't sand up into the chamber.

2) Any chance that you're using 147 grain ammo? (bullet size, shape)

3) What are your cleaning and lubrication methods? (friction)

4) New or used P-11? Any idea how many rounds total fired at this point? New recoil and mag springs might help if it's an older pistol.

5) What type of slide - blued, hard chrome, parkerized, nickel? (binding on rails)

Do you get misfeeds when the pistol cycles from being fired?

Regards, Keys 8)
 

· Premium Member
Joined
·
5,516 Posts
My particular P-11 didn't like the 135 grain HydraShoks. I shot four boxes of it back in the first few hundred rounds after I bought the pistol. I had misfeeds and some extraction problems. I stopped with the HydraShoks and never again had an extraction problem. Had no misfeeds after 300 rounds either. Now have over 3000 rounds throught m P-11.

Regards, Keys 8)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top