Kel-Tec Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
Now that I seem to have my trigger trouble under control....

I am ready to move on to my smilies issues.
I have less than 200 rounds rounds through my pistol and both of my mags followers are already beat to hell.

I have been studying the barrel to frame relationship.

I noticed that my barrel feedramp extends well into the magwell when in the unlocked position.

It overhangs slightly more than 0.065".
This is the first semi auto pistol that I have seen that is set up this way.

Is this what you are referring to in your "Rampectomy" modification?

There is also evidence of (bullet?) contact on the upper front edge of the mag well. The top front of my mags also show some flattening.
I will try to post a pic tonight showing traces of copper on the lower edge of the feedramp. If my camera will cooperate!
 

· Registered
Joined
·
38 Posts
Discussion Starter · #6 ·
Flyer,
FWIW..It really should'nt have tobe explained " Not to remove the feed ramp" I can only imagine how that would end .....

To tell you the truth I understood the meaning. I also understood that it is a simple trimming and relatively minor reshaping of the lower portion of the feedramp.

It sort of makes an uneducated man such as myself wonder who it was that surgically removed the entire feedramp :twisted:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top