Kel-Tec Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
Midiman,

Your right, you did mention that earlier, my bad! :oops: Trying to post question and respond between the different sites and working on the house and the kids, I get forgetful. :?

I trying to get caught up on the in's and out's of my new gun.

Thanks,
 

·
Registered
Joined
·
17 Posts
nfml gen 1 mags are very slightly shorter so the mag floor plate may contate the bottom of the mag well ever so slightly in my experience a firm tap os all that is required to seat them adequately. If this does not work for your sub try using fine grit sandpaper to polish the magwell so to speak.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top