Kel-Tec Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
I finally get to the range to test fire my little beauty.

Every single round I fired failed to eject out of three different mags. :cry:
My assumption is the extractor.

If i hand cycle the slide every round ejects but when I shoot it FTE every time.

One phone call to Kel-Tec and I explained the problem and in less than one minute the problem was identified, a bad extractor and spring.

As I write this the replacements are on their way.
The woman I spoke with at Kel-Tec was very patient with all of my questions and and had all the right answers.

My hats off to Kel-Tec. Great customer service.
 

·
Banned
Joined
·
5,800 Posts
Curious, here...
What's the Serial# range of your P-3AT? Is it a newer one with a lettered prefix, or one of the "Pre-OHD" (Office of Homeland Defense) ones with just the number?
Flyer
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
It's the newer one with the lettered prefix H8W##.
The person at Kel-Tec Seemed to know what the problem was right away.
 

·
Registered
Joined
·
24 Posts
Not to worry, Kel-Tec will fix it/make it right.

Not everyone has problems with their P3AT: I've fired about 400 rounds (CorBon and Remington UMC) and have had zero FTE/FTF misfires - it's been flawless.
 
1 - 4 of 4 Posts
Top