If you are like me, then you probably grab the entire slide when you rack your P3AT. Do you think it would be a good idea to have slide serration on the front end of the slide to give a better grip? Any thoughts about this being a bad idea?
Front end slide serrations
1 - 4 of 4 Posts
Skateboard Tape!!!
Feels like very fine grit. Cut small strips about 1/4 inch wide and an inch long, and apply to the sides of your slide.
This'll take care of the problems racking the slide.
I never cared much for forward slide serrations: they just don't LOOK right, on a 1911, at least.
Anyhow, this is easier to do, quicker, and probably works just as well!
Flyer
Feels like very fine grit. Cut small strips about 1/4 inch wide and an inch long, and apply to the sides of your slide.
This'll take care of the problems racking the slide.
I never cared much for forward slide serrations: they just don't LOOK right, on a 1911, at least.
Anyhow, this is easier to do, quicker, and probably works just as well!
Flyer
Joined
·
2,654 Posts
SERRATIONS
gaz, check my p11 in the p11 forum, "post pics" i have the tape on my gun. buy at lowes. if you want some free, pm me with your address and i'll send you a strip. i've got enough for 50 guns. i have arthritus in my left hand and i have found this really helps.
gaz, check my p11 in the p11 forum, "post pics" i have the tape on my gun. buy at lowes. if you want some free, pm me with your address and i'll send you a strip. i've got enough for 50 guns. i have arthritus in my left hand and i have found this really helps.
1 - 4 of 4 Posts
