Kel-Tec Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,327 Posts
felt tip

See that cone shaped felt tip in Midi's picture?? That's the one I use for polishing feed ramp, etc.

And a tip for the tip...Flyer is right. Use some rubbing alcohol, not water, to wet the polishing paste. I also wet the felt tip with alcohol and rub in into the paste. But then, here is the tip, hold the dremel down behind something, turn it on high speed for just a few seconds. The wet alcohol and excess paste will form a mist for a few feet. This will keep it off you when you turn it back on at medium speed to do the polishing. Works good.

og

(Midi must be in disquise, don't recognize him in new avatar)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top