[Gun_Nut_2k1]

I never liked the look of my Factory Base Plate on my SUB2000 with my S&W high Caps. I made one out of Aluminum today. Looks pretty good. One problem I have is because the aluminum is thicker than steal I had to mill a step with my file. now this step goes from front to back. I did not really like that so I rounded it off, but that leaves a small gap. Any suggestions? Sorry for the poor pic.

 

[Guest]

Uhhhhh......where's the pic?

 

[Gun_Nut_2k1]

Re:

Uhhhhh......where's the pic?

Opps!


BTW it is shaped to fit the SUB grip to aid in removal if needed. It fit very nicely and give you a little more push surface when inserting. The stock steal I had to push into the grip area.

 

[Guest]

Hold on, let me cut two circles out of the windshield of the space shuttle so I can focus on that pic!..... :jester:

 

[Gun_Nut_2k1]

Re:

Hold on, let me cut two circles out of the windshield of the space shuttle so I can focus on that pic!..... :jester:

 

[Guest]

I think that says it all..................but I was just kidding... :lol:

 

[Gun_Nut_2k1]

Re:

I think that says it all..................but I was just kidding... :lol:

I knows it bro. I'll try to get a better pic for you Hommie.... as the Youth might say it.

 

[Guest]

WORD!